Engineering, 19.07.2019 01:30 Cjohnston742

Water is drawn steadily by a pump at a volumetric flow rate of 0.8 m/min through a pipe with a 10 cm diameter inlet. the water is delivered to a tank placed at a height of 10 m above the pipe inlet. the water exits through a nozzle having a diameter of 2.5 cm. water enters at 25°c and 1 atm pressure but there is no significant change in pressure and temperature at exit. six percent of the power input to the pump is dissipated in the form of heat into the surroundings. take the value of acceleration due to gravity (g) equal to 9.8 m/s determine (a) the velocity of the water at the inlet and exit and (b) the power required by the pump.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

You know the right answer?

Water is drawn steadily by a pump at a volumetric flow rate of 0.8 m/min through a pipe with a 10 cm...

Questions