subject
Engineering, 19.07.2019 21:10 addisynshepherd

Atwo-stage double acting air compressor, operating at 150 revolutions per minute, takes in air at 96.5 kpa and 27 c. the diameter of the lp cylinder is 36 cm, the stroke of both the lp cylinder and the hp cylinder is 38 cm and the clearance of both cylinders is 4%. the lp cylinder discharges air at 386.0 kpa which passes through an intercooler and enters the hp cylinder at 27 c and 370 kpa after which it is discharged from the hp compressor at a pressure of 1482 kpa. the polytropic coefficient in both cylinders n 1.3. atmospheric pressure and temperature are 101.325 kpa and 20 c respectively. disregarding the effect of the piston rods at the crank ends of the cylinders, determine (a) how much heat is rejected in the intercooler (b) the diameter of the hp cylinder and (c) the power required. to drive each of the compressors

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.
Answers: 3
question
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
question
Engineering, 04.07.2019 19:10
Acircular aluminum shaft mounted in a journal is shown. the symmetric clearance gap between the shaft and journal is filled with sae 10w-30 oil at t 30°c. the shaft is caused to turn by the attached mass and cord. develop and solve a differential equation for the angular speed of the shaft as a function of time.
Answers: 2
question
Engineering, 06.07.2019 03:10
What is the direction and how to operate the lathe?
Answers: 2
You know the right answer?
Atwo-stage double acting air compressor, operating at 150 revolutions per minute, takes in air at 96...
Questions
question
Mathematics, 23.09.2021 14:00
question
English, 23.09.2021 14:00
question
Biology, 23.09.2021 14:00
question
Mathematics, 23.09.2021 14:00
question
Mathematics, 23.09.2021 14:00
question
Mathematics, 23.09.2021 14:00
question
Biology, 23.09.2021 14:00
question
Mathematics, 23.09.2021 14:00
question
Mathematics, 23.09.2021 14:00
Questions on the website: 13722361