Engineering, 19.07.2019 22:20 BrainGeek4848

Consider an underground fuel storage tank pressure in multiphase fluid scenarios: (horizontally-oriented cylinder of volume of 20,000 liters, length of 2 meters) that is 100% full of diesel and water (two separate phases, water is on the bottom). the diesel is present to a depth of 9/10ths of the tank diameter, while the water fills the last 1/10th of the tank diameter. the density of the diesel is 850 kgm/m2. if the very top of the tank is open to the atmosphere, what is the pressure (in kpa) at the bottom of the tank (give your answer in both absolute and gauge kpa)

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

You know the right answer?

Consider an underground fuel storage tank pressure in multiphase fluid scenarios: (horizontally-ori...

Questions