Engineering, 26.07.2019 18:10 lizzy2951
A20 mm deep slot is being milled in a block of aluminum with k 850 n/mm2. the tool is 25 mm in diameter, and has 2 teeth. it is rotating at 14,728 rpm, and the chip load (feed per tooth) is 0.1 mm. how much power is consumed in kw?
Answers: 2
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 06.07.2019 04:30
Mention two examples each of the direct and indirect measurement of force.
Answers: 3
Engineering, 06.07.2019 05:20
A8-in.-diameter steel shaft is to have a press fit with a 16-in-diameter cast iron hub. both the hub and the shaft are 10 in long. using maximum normal stress theorem and appropriate safety factor, it was identified that the maximum allowable circumferential (a.k.a. hoop or tangential) stress in the hub is to be 7.5 ksi. the moduli of elasticity are 30 x 106 psi for steel and 15 x 106 psi for cast iron. the poisson's ratio for both steel and cast ron is 0.3 and coefficient friction for the two materials is 0.12. determine a. the interference or the original mismatch, 8 b. the maximum axial force required to press the hub on the shaft
Answers: 1
A20 mm deep slot is being milled in a block of aluminum with k 850 n/mm2. the tool is 25 mm in diame...
Mathematics, 22.04.2020 07:48
Mathematics, 22.04.2020 07:48
Social Studies, 22.04.2020 07:48
Chemistry, 22.04.2020 07:48
Mathematics, 22.04.2020 07:48
Mathematics, 22.04.2020 07:48
Computers and Technology, 22.04.2020 07:48
Mathematics, 22.04.2020 07:48
World Languages, 22.04.2020 07:48
Engineering, 22.04.2020 07:48
Health, 22.04.2020 07:48
History, 22.04.2020 07:48