Arule of thumb says reducing the compressor discharge pressure by 2 psi reduces the power input by 1%. show that this is true when the discharge pressure is reduced from 110 psig to 100 psig. hint: recall that for isentropic compression from absolute inlet pressure pi to absolute discharge pressure pe, the absolute temperature ratio te/ti = (pe/pi)^[(k-1)/k], where k = cp/cv = 1.4 for air. assume the mass flow rates and compressor efficiency are about the same for both discharge pressures.

1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction

What is the direction and how to operate the lathe?

Explain the similarities and differences in the design guidelines for turning and for