Engineering, 26.07.2019 20:20 taylorb9893
When do you want to use shell feature? a)-make a 2d sketch of a gear b)-make a 3d model of a gear box c) make a 2d shell of a shaft (d) make a 3d mate for a cam
Answers: 2
Engineering, 04.07.2019 18:20
For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor
Answers: 3
Engineering, 06.07.2019 03:20
What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.
Answers: 3
Engineering, 06.07.2019 04:10
Areheat rankine cycle operates with water as the working fluid. steam enters the first turbine at 8 mpa and 450°c and exits at 0.8 mpa. it is then reheated to 400°c before entering the second turbine, where it exits at 10 kpa. if the amount of work into the pump is 8.04 kj/kg and the net work per cycle produced is 1410.25 kj/kg, determine the thermal efficiency of the cycle.
Answers: 3
Engineering, 06.07.2019 04:20
Consider a beam traveling through diamond and impinging upon the diamond-air interface. the critical angle of incidence for total internal reflection to occur is closest to the following value: select one: a)-22.50° b)-23.85 c)-24.30 d)-23.40° e)-none of the above
Answers: 3
When do you want to use shell feature? a)-make a 2d sketch of a gear b)-make a 3d model of a gear b...
Mathematics, 18.11.2020 01:40
Chemistry, 18.11.2020 01:40
Arts, 18.11.2020 01:40
English, 18.11.2020 01:40
Mathematics, 18.11.2020 01:40
Chemistry, 18.11.2020 01:40