Engineering, 03.08.2019 00:30 karreemgrant2

Oil with a density of 850 kg/m3 and kinematic viscosity of 0.00062 m2/s is being discharged by an 8-mm-diameter, 43-m-long horizontal pipe from a storage tank open to the atmosphere. the height of the liquid level above the center of the pipe is 4 m. disregarding the minor losses, determine the flow rate of oil through the pipe. solve this problem by making the assumption that since the velocity through the pipe is so small, the pressure at the pipe entrance is nearly the same as the hydrostatic pressure at that location.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 19:10

What is creep? what is stress relaxation?

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Asimple speed reducer is composed of 2 spur gears. the pinion gear has a pitch diameter of 0.75" and 36 teeth while the driven gear has a pitch diameter of 4.0" and 192 teeth. a)-what is the diametral pitch of each gear? b)-if an electric motor rotating ccw at 3000 rpm is coupled to the pinion, what is the rotational speed of the driven gear? c)-if the torque delivered to the pinion is 1 n-m, what is the torque on the driven gear? d)-what is the power transmitted by the gear train?

Answers: 1

Answer

Engineering, 06.07.2019 02:30

A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush

Answers: 3

Answer

You know the right answer?

Oil with a density of 850 kg/m3 and kinematic viscosity of 0.00062 m2/s is being discharged by an 8-...

Questions