Engineering, 07.08.2019 02:10 mxxrrr
Determine size of a standard square key made of 1045 hot rolled steel for a 2 inch dia shaft transmitting 100 hp at 500 rpm with factor of safety 2.5 for yield in direct shear.
Answers: 2
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 04.07.2019 18:10
Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables
Answers: 1
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 19:10
Aplate of dimensions 3 m x 3 m is placed 0.37 mm apart from a fixed plate. the plate requires a force of 2n to move at speed of 45 cm/s. evaluate the viscosity of the fluid in between the plates
Answers: 3
Determine size of a standard square key made of 1045 hot rolled steel for a 2 inch dia shaft transmi...
Mathematics, 24.06.2021 23:10
Mathematics, 24.06.2021 23:10
Biology, 24.06.2021 23:10
Medicine, 24.06.2021 23:10
Computers and Technology, 24.06.2021 23:10
Mathematics, 24.06.2021 23:10
English, 24.06.2021 23:10
Mathematics, 24.06.2021 23:10
Physics, 24.06.2021 23:10