Engineering, 07.08.2019 18:10 aredding7016
Which of the following is not considered as a critical location in shaft design for stress? a) on the outer surface b) where the bending moment is minimum c) where the torque is present d) where stress concentrations exist
Answers: 1
Engineering, 04.07.2019 18:10
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
Which of the following is not considered as a critical location in shaft design for stress? a) on t...
Mathematics, 01.11.2019 12:31
English, 01.11.2019 12:31
History, 01.11.2019 12:31
Mathematics, 01.11.2019 12:31
Mathematics, 01.11.2019 12:31
History, 01.11.2019 12:31
Social Studies, 01.11.2019 12:31
Health, 01.11.2019 12:31