Engineering, 21.08.2019 04:30 SKYBLUE1015

Acooling coil with a cross sectional area of 20 ft is employed to cool from 95 f dh75 f wb to s8.0 f dry-bulb temperature with chilled water entering the coil at 42 f. face velocity should not exceed 500 fpm. assume water velocity to be 6 f's and water temperature rise wtr st. determine (o) the volume flow rate (b) the number of rows (c) the number of fins per foot (d) the rate of heat transfer in the coil in tons and (e) the rate of latent heat transfer in the coil in tons

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

You know the right answer?

Acooling coil with a cross sectional area of 20 ft is employed to cool from 95 f dh75 f wb to s8.0 f...

Questions