subject
Engineering, 21.08.2019 21:30 aryal191

Aprojectile in flight canties with it a more or less conical-shaped shock front. from physical reasoning it appears that at great distance from the projectile this shock wave becomes truly conical and changes in vclocity and density across the shock becomes vanishingly small. photographs of a bullet in light show that at a great distance from the bullet the lotal included angle of the conç is 50,30°. the pressure and lymperature of the undisturbed air ir 100.801 kpa and 22.78°c. respectively. calculate thç velocity of the bullet, and the mach number of the bullcl. relative lu the undisturbed air.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:20
Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]
Answers: 1
question
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
You know the right answer?
Aprojectile in flight canties with it a more or less conical-shaped shock front. from physical reaso...
Questions
question
Mathematics, 16.08.2021 06:30
question
Business, 16.08.2021 06:40
question
Mathematics, 16.08.2021 06:40
Questions on the website: 13722361