Engineering, 21.08.2019 22:30 hunteryolanda82

The design procedure is generally based on determining the shaft diameter 'd' for a given torque transmission. the different dimensions of the coupling are then obtained based on the shaft diameter using some empirical relations. check for different failure modes are then be carried out. design a typical rigid flange coupling for connecting a motor and a centrifugal pump shafts. the coupling needs to transmit 15 kw at 1000 rpm. the allowable shear stresses of the shaft, key and bolt materials are 60 mpa, 50 mpa and 25 mpa respectively. the shear modulus of the shaft material may be taken as 84gpa. the angle of twist of the shaft should be limited to 1 degree in 20 times the shaft diameter. due to some unavoidable condition, the coupling starts transmitting a varying load from 12.5 kw to 15 kw at 1000 rpm. redesign the centrifugal pump shaft and the corresponding components accordingly.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

Answer

Engineering, 04.07.2019 18:10

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Acommercial grade cubical freezer, 4 m on a side, has a composite wall consisting of an exterior sheet of 5.0-mm thick plain carbon steel (kst= 60.5 w/m k), an intermediate layer of 100-mm thick polyurethane insulation (kins 0.02 w/m k), and an inner sheet of 5.0- mm thick aluminium alloy (kal polyurethane insulation and both metallic sheets are each characterized by a thermal contact resistance of r 2.5 x 104 m2 k/w. (a) what is the steady-state cooling load that must be maintained by the refrigerator under conditions for which the outer and inner surface temperatures are 25°c and -5°c, respectively? (b) for power saving purpose, which wall material should be increased/reduced in. thickness in order to reduce 50% of the cooling load found in part (a)? redesign the thickness of the proposed material. 177 w/m-k). adhesive interfaces between the q=575.93 w

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Acarnot refrigerator operates in a room in which the temperature is 21°c and of power when operating. if the food compartment of the refrigerator is consumes 3 kw to be maintained at 2°c, determine (a) the coefficient of performance of the cycle and (b) the rate of heat removal from the food compartment. refrigerator cycle that has a higher coefficient of performance than that of the discussed (e) is it possible to develop a carn ot refrigerator, operating between the same temperature limits? explain

Answers: 2

Answer

You know the right answer?

The design procedure is generally based on determining the shaft diameter 'd' for a given torque tra...

Questions