Engineering, 22.08.2019 01:20 Gghbhgy4809
Asteam power plant operates on a kpa in the boiler and condenser, respectively. due to the metallurgic limits in fabrication of the turbine blades, the maximum temperature in the cycle is not to exceed 500 °c. the isentropic efficiency is 85% for both the turbine and the pump. simple nonideal rankine cycle between the pressure limits of 10 mpa and 10 (a) show the cycle on a t-s diagram with respect to the saturation lines. (b) solve for the rate of work done by the compressor on the steam flow (c) determine the rate of heat input and output in the boiler and condenser, respectively, when the power plant operates at its maximum capacity (d) determine the thermal efficiency of the cycle. (e) what is the required mass flow rate of the steam through the cycle to generate 210 mw in the power plant?
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
You know the right answer?
Asteam power plant operates on a kpa in the boiler and condenser, respectively. due to the metallurg...
Questions
Mathematics, 26.02.2020 01:02
Biology, 26.02.2020 01:02
History, 26.02.2020 01:02
Arts, 26.02.2020 01:02
Chemistry, 26.02.2020 01:02
