Engineering, 22.08.2019 21:00 tomoetoes6910
For music wire, a = 2211 mpa-mmm, m = 0.145. a. what would be the tensile strength, sut, be if the wire diameter is 1.0 mm? b. how would you expect the tensile strength to vary if the diameter were doubled? would it increase, decrease or stay the same? c. what would be the tensile strength, sut, be if the wire diameter is 2.0 mm? d. how does this compare to your expectation in part b?
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Burgers vector is generally parallel to the dislocation line. a)-true b)-false
Answers: 2
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
You know the right answer?
For music wire, a = 2211 mpa-mmm, m = 0.145. a. what would be the tensile strength, sut, be if the w...
Questions
Mathematics, 04.02.2022 22:50
Mathematics, 04.02.2022 22:50
Mathematics, 04.02.2022 22:50
Law, 04.02.2022 23:00
History, 04.02.2022 23:00
Business, 04.02.2022 23:00
English, 04.02.2022 23:00
Spanish, 04.02.2022 23:00
Mathematics, 04.02.2022 23:00
Geography, 04.02.2022 23:00
