Engineering, 28.08.2019 02:30 suselygonza
In 3d modeling the combinations of keys that you use to give the program instructions is called
what?
manual
instructions
commands
okeywords
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.
Answers: 1
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 04.07.2019 18:10
An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0
Answers: 3
You know the right answer?
In 3d modeling the combinations of keys that you use to give the program instructions is called
Questions
Mathematics, 24.02.2021 01:00
Mathematics, 24.02.2021 01:00
Mathematics, 24.02.2021 01:00
Mathematics, 24.02.2021 01:00
Mathematics, 24.02.2021 01:00
Mathematics, 24.02.2021 01:00
Mathematics, 24.02.2021 01:00
