subject
Engineering, 30.08.2019 00:20 Geo777

Agenerator is to be driven by a small pelton wheel with a head of 91.5m at inlet to the nozzle and discharge of 0.04m^3/s. the wheel rotates at 720rpm a n d the velocity coefficient of the nnozzle is 0.98. if the efficiency of the wheel (based on the energy available at entry to the nozzle) is 80 per cent and the ratio of bucket speed to jet speed is0.46, determine the wheel-to-.jet-di meter ratio at the centre-line of the buckets, and the speed of the wheel. what is the dimensionless power specific speed of the wheel?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
question
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
question
Engineering, 04.07.2019 19:10
With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.
Answers: 1
question
Engineering, 04.07.2019 19:20
Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3
Answers: 2
You know the right answer?
Agenerator is to be driven by a small pelton wheel with a head of 91.5m at inlet to the nozzle and d...
Questions
question
Biology, 26.04.2021 22:00
question
Mathematics, 26.04.2021 22:00
Questions on the website: 13722361