subject
Engineering, 10.09.2019 18:30 elielson1497

The deepest part in the ocean is the challenger deep within the mariana trench, which has a maximum depth of around 11,000 m. this question will look to estimate the pressure at this depth in the ocean. (a) (2 points) assuming that the salt water in the ocean has a constant density of 1030 kg/m", compute the pressure at this deepest point in the ocean. use gage (relative) pressure, with p= 0 pa at the surface. (b) (4 points) while liquids are approximately incompressible, at such depths density variations can be noticeable. assume that the density of the water varies with depth by the equation p- po ppo cape p= po exp where po and po are the density and pressure at the surface, and ey = 2.3 x 10° n/m² is the modulus of elasticity of water. using the differential form of the hydrostatic pressure equation dp da = -29, determine the pressure at the deepest point of the challenger deep. as- sume that po = 1030 kg/m². how does this compare to your answer for part (a)?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
question
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
question
Engineering, 04.07.2019 18:10
Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k
Answers: 2
question
Engineering, 04.07.2019 19:10
Arigid tank contains 10 kg of air at 137 kpa (abs) and 21°c. more air is added to the tank until the pressure and temperature rise to 242 kpa (abs) and 32°c, respectively. determine the amount of air added to the tank. [r-0.287 kj/kg k]
Answers: 3
You know the right answer?
The deepest part in the ocean is the challenger deep within the mariana trench, which has a maximum...
Questions
question
Mathematics, 20.11.2020 01:00
question
Mathematics, 20.11.2020 01:00
question
Advanced Placement (AP), 20.11.2020 01:00
Questions on the website: 13722363