Engineering, 13.09.2019 20:30 sw2098
Two wooden members of uniform rectangular cross section as joined by the simple glued scarf splice shown. knowing that the maximum allowable shearing stress in the glued splice in 620 kpa, determine (a) the largest load p that can be safely applied, (b) the corresponding tensile stress in the splice. a steel pipe of 12-in. outer diameter is fabricated from 1 / 4-in.-thick plate by welding along a helix that forms an angle of 25 degree with a plane perpendicular to the axis of the pipe. knowing that the maximum allowable normal and shearing stresses in the direction respectively normal and tangential to the weld are sigma = 12 ksi and tau = 7.2 ksi, determine the magnitude p of the largest axial force that can be applied to the pipe. a steel pipe of 12-in. outer diameter as fabricated from 1 / 4-in.-thick plate by welding along a helix that forms an angle of 25 degree with plane perpendicular to the axis of the pipe. knowing that a 66 ksi axial force p is applied to the pipe, determine the normal and shearing stresses in directions respectively normal and tangential to the weld.
Answers: 1
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 06.07.2019 03:20
What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.
Answers: 3
Two wooden members of uniform rectangular cross section as joined by the simple glued scarf splice s...
Biology, 11.10.2020 03:01
Physics, 11.10.2020 03:01
Geography, 11.10.2020 03:01
History, 11.10.2020 03:01
History, 11.10.2020 03:01
Mathematics, 11.10.2020 03:01
Mathematics, 11.10.2020 03:01
Mathematics, 11.10.2020 03:01