Engineering, 13.09.2019 23:30 oliviaboils
Acylindrical part is warm upset forged in an open die. the starting work piece is 50 mm in diameter, and 40 mm in hieght. the final height=20mm. coefficent of friction at the die-work interface =0.2. the work material has a flow curve defined by k=600 mpa, and n=0.12. determine the force in the operation at process begins, at intermediate height of 30 mm, and at the final height of 20 mm.
Answers: 3
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
Acylindrical part is warm upset forged in an open die. the starting work piece is 50 mm in diameter,...
Social Studies, 24.11.2021 14:00
Social Studies, 24.11.2021 14:00
Mathematics, 24.11.2021 14:00
Computers and Technology, 24.11.2021 14:00
History, 24.11.2021 14:00
Mathematics, 24.11.2021 14:00
English, 24.11.2021 14:00
Mathematics, 24.11.2021 14:00
History, 24.11.2021 14:00
French, 24.11.2021 14:00
Computers and Technology, 24.11.2021 14:00