Engineering, 14.09.2019 04:30 jeffreystarks
If in turning of a steel rod by a given cutting tool (material and geometry) at a given machining c ondition (so and t) under a given environment (cutting fluid application), the tool life decreases from 80 min to 20 min. due to increase in cutting velocity, vc from 60 m/min to 120 m/min., th en at what cutting velocity the life of that tool under the same condition and environment will b e 40 min.?
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
Engineering, 04.07.2019 18:10
What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information
Answers: 3
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
You know the right answer?
If in turning of a steel rod by a given cutting tool (material and geometry) at a given machining c...
Questions
Mathematics, 23.05.2020 01:01
Chemistry, 23.05.2020 01:01
Social Studies, 23.05.2020 01:01
History, 23.05.2020 01:01
History, 23.05.2020 01:01
Mathematics, 23.05.2020 01:01
Mathematics, 23.05.2020 01:01
