Which is true about the dimensions on a blueprint?
possible answers:
the features of t...
Engineering, 16.09.2019 20:00 microwave13016
Which is true about the dimensions on a blueprint?
possible answers:
the features of the drawing are measured to find accurate dimensions.
the notes section indicates the best way to calculate the dimensions.
the dimensions are listed separately from the part drawing.
the measurements are often given in decimals rather than fractions.
Answers: 1
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 04.07.2019 18:10
Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
Biology, 19.08.2019 16:00
Social Studies, 19.08.2019 16:00
Health, 19.08.2019 16:00
Biology, 19.08.2019 16:00
Biology, 19.08.2019 16:00
Social Studies, 19.08.2019 16:00
Mathematics, 19.08.2019 16:00
Mathematics, 19.08.2019 16:00
Chemistry, 19.08.2019 16:00
Social Studies, 19.08.2019 16:00