15 points !
1.) christopher finishes culinary school and decides to become a private catere...
![subject](/tpl/images/cats/User.png)
Engineering, 16.09.2019 22:30 carrietaylor234
15 points !
1.) christopher finishes culinary school and decides to become a private caterer. he finds his own customers, goes to their homes for special events, and cooks a meal for them. which of the following is true about christopher's job?
a) christopher has a traditional job.
b) christopher works remotely.
c) christopher is an entrepreneur
d) christopher's job has been outsourced.
![ansver](/tpl/images/cats/User.png)
Answers: 2
Another question on Engineering
![question](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
![question](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
![question](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
![question](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
You know the right answer?
Questions
![question](/tpl/images/cats/mat.png)
![question](/tpl/images/cats/health.png)
![question](/tpl/images/cats/mat.png)
Mathematics, 13.12.2021 21:00
![question](/tpl/images/cats/en.png)
![question](/tpl/images/cats/mat.png)
Mathematics, 13.12.2021 21:00
![question](/tpl/images/cats/mat.png)
Mathematics, 13.12.2021 21:00
![question](/tpl/images/cats/fizika.png)
Physics, 13.12.2021 21:00
![question](/tpl/images/cats/mat.png)
Mathematics, 13.12.2021 21:00
![question](/tpl/images/cats/mat.png)
Mathematics, 13.12.2021 21:00
![question](/tpl/images/cats/en.png)
![question](/tpl/images/cats/mat.png)
![question](/tpl/images/cats/istoriya.png)
History, 13.12.2021 21:00
![question](/tpl/images/cats/biologiya.png)
Biology, 13.12.2021 21:00
![question](/tpl/images/cats/mat.png)
Mathematics, 13.12.2021 21:00
![question](/tpl/images/cats/en.png)
![question](/tpl/images/cats/geografiya.png)
![question](/tpl/images/cats/istoriya.png)
![question](/tpl/images/cats/fizika.png)
Physics, 13.12.2021 21:00
![question](/tpl/images/cats/mat.png)