Engineering, 18.09.2019 03:00 ImmortalEnigmaYT

Voltage controlled current source. for a photoplethysmogram amplifier (which you will learn about later in the class), you will need to design a high quality, precision current source to drive the leds to output light into the body. specifically, you will need to output the following current into the led: i(t) = 5ma + 2ma * cos(2pi1000t). your teammate on the project has created a very precise voltage output using an oscillator circuit with the following waveform: v(t) = 1 v cos(2pi1000*t). design a circuit that will provide the desired current for the led based on the output of this oscillator. what is the output resistance of your circuit (assuming ideal op amp conditions)?

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false

Answers: 2

Answer

Engineering, 06.07.2019 02:30

A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush

Answers: 3

Answer

You know the right answer?

Voltage controlled current source. for a photoplethysmogram amplifier (which you will learn about la...

Questions