Engineering, 18.09.2019 22:20 ejohnstonee111

Arod of diameter d=25mm and thermal conductivity k=60w/(mk) protrudes normally from a furnace wall that is at tw=200°c and is covered by insulation of thickness lins=200mm. the rod is welded to the furnace wall and is used as a hanger to support instrumentation cables. to avoid damaging the cables, the temperature of the rod at its exposed surface, to, must be maintained below a specified operating limit of tmax=100°c. the ambient air temperature is 30°c, and the convection coefficient is 17.0 w/(m2k). a) derive an expression for the exposed surface temperature, to, as a function of the prescribed thermal and geometrical parameters. the rod has an exposed length lo, and the tip is well insulated. b) will a rod of length lo=180mm meet the specified operating limit? if not, which design parameters would you change? note the variables and whether increasing or decreasing them would change to.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

You know the right answer?

Arod of diameter d=25mm and thermal conductivity k=60w/(m*k) protrudes normally from a furnace wall...

Questions