Engineering, 20.09.2019 22:30 vitanoeymailcom705

Alight-emitting diode (led) is a component that produces light. when an led has current running through it, we sometimes make the rough approximation that the voltage across the led is constant regardless of how much forward current is flowing through it (within a certain range of current). this approximately constant voltage is given the designation vf. led data sheets specify the current to be used through the device when lighting it; this current is given the designation if. choose a resistor r1 (specify a resistance and power rating as your answer) to be used in the following circuit to illuminate a red led with a vs = 6 v battery. this red led has if = 20 ma and vf = 1.4 v. use the smallest power rating possible for the resistor; you have the following resistor power ratings available: 1/16 w, 1/8 w, 1/4 w, 1/2 w, and 1w. the actual power dissipated by the resistor should not exceed the power rating of the resistor you choose. (you do not need to choose a standard resistance value for the resistor.)

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

You know the right answer?

Alight-emitting diode (led) is a component that produces light. when an led has current running thro...

Questions