Engineering, 23.09.2019 21:30 dondre54

Asmall machine has an axis with a pulley-belt drive and a rotating load. the motion profile is trapezoidal with ta = td = 20 ms, tm = 3s, tdw = 0s. the pulley-belt drive has aluminum pulleys (rip = 1.6 cm, rlp = 4 cm radii, 1.2 cm pulley thickness, ⇢ = 2810 kg/m3, and ⌘ = 0.9). the belt weighs 50 gr. all coupler inertias are negligible. the load has jload = 1.5 ⇥ 104 kg m2 inertia, ! load = 800 rpm, and text = 1.3nm torque. select an akm2x series servo motor (320 vdc supply) from the kollmorgen catalog for this axis

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 19:10

The proportional limit is always greater than the yield strength for a material. a)-trune b)- false

Answers: 3

Answer

Engineering, 04.07.2019 19:10

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed

Answers: 3

Answer

You know the right answer?

Asmall machine has an axis with a pulley-belt drive and a rotating load. the motion profile is trape...

Questions