Engineering, 29.09.2019 01:10 asapmechee
Afeature control frame is to indicate a surface requirement.
Answers: 3
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
Afeature control frame is to indicate a surface requirement....
Mathematics, 10.02.2021 08:10
Mathematics, 10.02.2021 08:10
English, 10.02.2021 08:10
History, 10.02.2021 08:10
History, 10.02.2021 08:10
English, 10.02.2021 08:10
Biology, 10.02.2021 08:10
Social Studies, 10.02.2021 08:10
History, 10.02.2021 08:10
Mathematics, 10.02.2021 08:10
Mathematics, 10.02.2021 08:10
Mathematics, 10.02.2021 08:10
Mathematics, 10.02.2021 08:10
History, 10.02.2021 08:10