subject
Engineering, 05.10.2019 05:20 dondre54

In the commercial production of sugar (sucrose), the product crystals are washed and centrifuged to partial dryness. the crystals are then sent through a rotary dryer where they are contacted with a hot stream of air that reduces the moisture content from 1: 0 wt% to 0: 1 wt%. the ratio of wet sugar to inlet air fed to the dryer is 3.3 kg wet sugar/kg inlet air. the inlet air contains 1.5 mole% water. (a) draw and label the flowchart and do the degree-of-freedom analysis

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
question
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
question
Engineering, 04.07.2019 19:10
The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]
Answers: 3
You know the right answer?
In the commercial production of sugar (sucrose), the product crystals are washed and centrifuged to...
Questions
question
Mathematics, 29.03.2020 22:58
Questions on the website: 13722363