Engineering, 07.10.2019 19:20 datstepparoddoe27

G2) steel rod (1) is fastened to brass rod (2) with a pin at b. the diameter of the pin is 7 /8 in. both rods are fixed at their ends a and c. the cross-sectional area of the steel rod is 1 in2 and the brass rod 1.5 in2 . the coefficient of thermal expansion for the steel is 6.5 x 10-6 /°f and its elastic modulus is 29 x 103 ksi. the coefficient of thermal expansion for the brass is 11.3 x 10-6 /°f and its elastic modulus is 15 x 103 ksi. a) the temperature drops 40°f. write the equilibrium and compatibility equation(s) needed to solve the problem along with supporting sketches. b) calculate the internal force in members (1) and (2) in kips. indicate tension or compression. [ans. to check: f1 = 9.2 k] c) calculate the average normal stress in each member in ksi. indicate tension or compression. d) compute the shear stress in the pin at b in ksi. [ans. to check: τ = 15.3 ksi] e) calculate the movement at b in inches. clearly indicate direction.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:20

To save energy, the air supply to a 2000 ft office has been shut off overnight and the room temperature has dropped to 40°f. in the morning, the thermostat is reset to 70°f and warm air at 120 f begins to flov in at 200ft'/min. the air is well mixed within the room, and an equal mass flow of air at room temperature (changing with time) is withdrawn through a return duct. the air pressure is nearly 1 atm everywhere. ignoring heat transfer with the surroundings and kinetic and potential energy effects, estimate how long it takes for the room temperature to reach 70°f. plot the room temperature as a function of time.

Answers: 1

Answer

Engineering, 05.07.2019 19:10

Tech a says never use a water hose to clean up dust after a repair. tech b says never use a floor scrubber to clean up dust after repairs. who is correct?

Answers: 1

Answer

Engineering, 06.07.2019 04:20

Aflow moves in the x direction with a velocity of 10 m/s from 0 to 0.1 second and then reverses direction with the same speed from 0.1 to 0.2 second. sketch the pathline strating from x-0 and the streak! ine with dye introduced at x=0. show the streamlines for the first time interval and the second time interval.

Answers: 3

Answer

Engineering, 06.07.2019 05:20

Adrawing operation is to be performed on a perfectly plastic material with strength coefficient- 100 mpa and strain hardening exponent-0. neglect redundant strain. die/work material friction coefficient=0 a)-what is the drawing stress? if this stress is a function of the area reduction, state so. b)-what is the strength of the material after drawing? if this strength is a function of the area 4. reduction, state so. c)-what is the maximum area reduction possible?

Answers: 3

Answer

You know the right answer?

G2) steel rod (1) is fastened to brass rod (2) with a pin at b. the diameter of the pin is 7 /8 in....

Questions