Engineering, 08.10.2019 00:00 kylediedrich1343

Assume that you are going to use this converter in another pv application. as before, assume that the capacitor ‘c’ is large and the converter is loss-less. the pv voltage (vi) can vary from 20 v to 30 v, but the converter output voltage (v) is regulated at 180 v. dc power (po) of the converter can be between 100 w and 220 w at any pv voltage (vi), depending on solar intensity. assume a converter switching frequency of your choice between 30 khz and 65 khz. (a) what is the minimum transformer turns ratio ‘1: n: n’ required for this application?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

You know the right answer?

Assume that you are going to use this converter in another pv application. as before, assume that th...

Questions