Engineering, 09.10.2019 01:30 valerrry

Arod of diameter d=25mm and thermal conductivity k=60w/(mk) protrudes normally from a furnace wall that is at tw=200°c and is covered by insulation of thickness lins=200mm. the rod is welded to the furnace wall and is used as a hanger to support instrumentation cables. to avoid damaging the cables, the temperature of the rod at its exposed surface, to, must be maintained below a specified operating limit of tmax=100°c. the ambient air temperature is 30°c, and the convection coefficient is 17.0 w/(m2k). a) derive an expression for the exposed surface temperature, to, as a function of the prescribed thermal and geometrical parameters. the rod has an exposed length lo, and the tip is well insulated. b) will a rod of length lo=180mm meet the specified operating limit? if not, which design parameters would you change? note the variables and whether increasing or decreasing them would change to.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 19:20

A5 kg block of fe is dropped into a very large vat of water. the fe and water initial temperatures are 95 and 25 c, respectively. the fe final temperature is 25 c and the water can be treated as a thermal reservoir,. treated as a thermal reservoir take the water to be the system and determine the entropy generation. report vour answer in kj/k.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Asimple speed reducer is composed of 2 spur gears. the pinion gear has a pitch diameter of 0.75" and 36 teeth while the driven gear has a pitch diameter of 4.0" and 192 teeth. a)-what is the diametral pitch of each gear? b)-if an electric motor rotating ccw at 3000 rpm is coupled to the pinion, what is the rotational speed of the driven gear? c)-if the torque delivered to the pinion is 1 n-m, what is the torque on the driven gear? d)-what is the power transmitted by the gear train?

Answers: 1

Answer

You know the right answer?

Arod of diameter d=25mm and thermal conductivity k=60w/(m*k) protrudes normally from a furnace wall...

Questions