Engineering, 09.10.2019 19:00 ziahziah

Ahollow steel shaft is to transmit 4200n-mof torque and is to be sized so that the torsional stress does not exceed 120mpa . if the inside diameter is 70 per sent of the out side diameter what size shaft should be used .use preferd size . what is stress of the inside of the shaft when full torque is applied

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 18:20

What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.

Answers: 3

Answer

You know the right answer?

Ahollow steel shaft is to transmit 4200n-mof torque and is to be sized so that the torsional stress...

Questions