Engineering, 10.10.2019 00:00 StupidFatChipmunk

1. what is the linear distance traveled in one revolution of a 9 in diameter wheel?

2. an industrial water shutoff valve is designed to operate with 15 ib of effort force. the valve will encounter 155 ib of resistance force applied to a 0.85 in diameter axle. what is the actual mechanial advantage of the sytem?

3. if the diameter of the wheel is 10.5 inches, what is the efficiency of the wheel and axle system?

4. a block and tackle system with 8 supporting strands is used to lift materials in a manufacturing facility. the motor being used to wind the cable in the pulley system can provide 200 ib of force. what is the ideal mechanical advantage of the pulley system?

5. ideally what is the maximum weight of materials that can be lifted?

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

You know the right answer?

1. what is the linear distance traveled in one revolution of a 9 in diameter wheel?

2....

Questions