Engineering, 16.10.2019 05:20 itzia00

Acartridge electrical heater is shaped as a cylinder of length l = 300 mm and outer diameter d = 30 mm. under normal operating conditions, the heater dissipates 2 kw while submerged in a water flow that is at 20 c and provides a convection heat transfer coefficient of ° w/m2 h = 5000 k. neglecting heat transfer from the ends of the heater, determine its surface temperature ts and the thermal resistance due to convection. if the water flow is inadvertently terminated while the heater continues to operate, the heater surface is exposed to air that is also at c but for which w/m2 20° h = 50 k. what are the corresponding thermal resistance due to convection and surface temperature? what are the consequences of such an event?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

Engineering, 04.07.2019 18:20

For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.

Answers: 1

Answer

You know the right answer?

Acartridge electrical heater is shaped as a cylinder of length l = 300 mm and outer diameter d = 30...

Questions