Engineering, 22.10.2019 19:00 michaelgg9299

You have two features x_1x 1 = vibration intensity, and x_2x 2 = heat generated. both x_1x 1 and x_2x 2 take on values between 0 and 1 (and are strictly greater than 0), and for most "normal" engines you expect that x_1 \approx x_2x 1 ≈x 2 . one of the suspected anomalies is that a flawed engine may vibrate very intensely even without generating much heat (large x_1x 1 , small x_2x 2 ), even though the particular values of x_1x 1 and x_2x 2 may not fall outside their typical ranges of values. what additional feature x_3x 3 should you create to capture these types of anomalies:

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

Engineering, 06.07.2019 03:20

Aparticle moves along a straight line such that its acceleration is a=(4t^2-2) m/s, where t is in seconds. when t = 0, the particle is located 2 m to the left of the origin, and when t = 2, it is 20 m to the left of the origin. determine the position of the particle when t=4s.

Answers: 1

Answer

You know the right answer?

You have two features x_1x 1 = vibration intensity, and x_2x 2 = heat generated. both x_1x 1 and...

Questions