Engineering, 23.10.2019 00:30 Jenniferwolf

The wall of drying oven is constructed by sandwiching insulation material of thermal conductivity k = 0.05 w/m°k between thin metal sheets. the oven air is at = 300℃, and the corresponding convection coefficient is ℎ = 30 w/ m2 °k. the inner wall absorbs a radiant flux of ′′= 100 w/ m2 from hotter objects within the oven. the room air at t[infinity],o= 25℃, and overall coefficient for convection and radiation from the outer surface is ℎo = 10 w/ m2 °k. what insulation thickness l is required to maintain the outer wall surface at a safe-to-touch temperature of to = 40 degree c?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Starting wih an energy balance on a rectangular volume element, derive the one- dimensional transient heat conduction equation for a plane wall with constant thermal conductivity and no heat generation.

Answers: 1

Answer

You know the right answer?

The wall of drying oven is constructed by sandwiching insulation material of thermal conductivity k...

Questions