Engineering, 23.10.2019 04:00 ltorline123

On july 23, 1983, air canada flight 143 required 22,300 kg of jet fuel to fly from montreal to edmonton. the density of jet fuel is 0.803 g/ml, or 1.77 lb/l. the plane had 7682 l of fuel on board in montreal. the ground crew there multiplied the 7682 l by the factor 1.77(without units) and concluded that they had 13,597 kg of fuel on board and needed an additional 8703 kg by the factor 1.77(again without units) and concluded they needed to add 4916 l of fuel. they added 5000l. on its flight, the plane ran out of fuel and crash-landed near winnipeg, hundreds of kilometers short of its destination. (there were few injuries and no fatalities.) what mistake did the ground crew make? how much fuel(in l) should they have added before takeoff?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

You know the right answer?

On july 23, 1983, air canada flight 143 required 22,300 kg of jet fuel to fly from montreal to edmon...

Questions