subject
Engineering, 24.10.2019 05:00 TheaMusic524

Write a function maxmagnitude() with two integer input parameters that returns the largest magnitude value. use the function in a program that takes two integer inputs, and outputs the largest magnitude value. ex: if the inputs are: 5 7 the function returns: 7 ex: if the inputs are: -8 -2 the function returns: -8 note: the function does not just return the largest value, which for -8 -2 would be -2. though not necessary, you may use the absolute-value built-in math function. your program must define and call a function: int maxmagnitude(int userval1, int userval2)

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point.the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.
Answers: 1
question
Engineering, 04.07.2019 19:20
Determine the time of the day and month of the year at which the peak sensible cooling load occurs for a top floor, north-eastern corner room of an office building in durban for the following conditions: floor area: 8 x 8 x 3 m east and north walls: 115 mm face brick (outside), 20 mm air space, 115 mm ordinary brick (inside) with 15 mm plaster roof construction: suspended plasterboard ceiling, 450 mm air space, 150 mm concrete, 75mm screed, waterproofing no heat transfer across other surfaces window area 3x 1,5 m high in north wall only. ordinary glass with venetian blinds. lights and occupants : from 07: 00 to 18: 00 average light density: 25 w/m2 number of occupants : 5 seated, light office work room temperature 24°c
Answers: 3
question
Engineering, 06.07.2019 02:30
On solidification from a melt, the polymer polyethylene forms a semi-crystalline spherulite structure. (i) sketch an individual spherulite and label the amorphous and crystalline regions. (ii) draw a schematic to show the changes in specific volume with temperature during cooling from the melt, comparing it to the theoretical extremes of fully crystalline and fully amorphous (indicate tm and tg)
Answers: 2
question
Engineering, 06.07.2019 04:20
Assume that you are asked to perform a boring operation on a large-diameter hollow workpiece. would you use a horizontal or a vertical boring mill?
Answers: 3
You know the right answer?
Write a function maxmagnitude() with two integer input parameters that returns the largest magnitude...
Questions
question
Mathematics, 27.06.2019 14:10
question
Computers and Technology, 27.06.2019 14:10
question
Mathematics, 27.06.2019 14:10
Questions on the website: 13722363