subject
Engineering, 25.10.2019 21:43 esmelopez1015

Steam enters the condenser of a vapor power plant at 0.1 bar with a quality of 0.95 and condensate exits at 0.1 bar and 45°c. cooling water enters the condenser in a separate stream as a liquid at 20°c and exits as a liquid at 35°c with no change in pressure. heat transfer from the outside of the condenser and changes in the kinetic and potential energies of the flowing streams can be ignored. for steady-state operation, determine: (a) the ratio of the mass flow rate of the cooling water to the mass flow rate of the condensing stream. (b) the rate of energy transfer from the condensing steam to the cooling water, in kj per kg of steam passing through the condenser.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:20
Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k
Answers: 2
question
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
You know the right answer?
Steam enters the condenser of a vapor power plant at 0.1 bar with a quality of 0.95 and condensate e...
Questions
question
Health, 10.06.2021 17:00
question
Mathematics, 10.06.2021 17:00
question
Mathematics, 10.06.2021 17:00
question
Mathematics, 10.06.2021 17:00
question
Mathematics, 10.06.2021 17:00
Questions on the website: 13722361