Engineering, 30.10.2019 02:31 jrfranckowiak
In experiment 1, when you measured the output with the 51 ohm resistor load in place, you probably still noticed some loading effect. this is because an op amp can only output a certain amount of current before it begins behaving nonlinearly. every op amp has a maximum positive current, called "sourcing current", that it can generate to drive a load. (likewise there is also a maximum negative current, called "sinking current" that can flow into the output terminal of the op amp.) look up the lf412 spec sheet and find nominal value(s) for this sourcing current limit. based on this value, determine the minimum load resistance that could be driven by the lf412 op amp without experiencing any loading effects in experiment 1.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Engineering, 04.07.2019 19:10
Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.
Answers: 1
Engineering, 04.07.2019 19:10
Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)
Answers: 3
You know the right answer?
In experiment 1, when you measured the output with the 51 ohm resistor load in place, you probably s...
Questions
English, 15.11.2019 22:31
Social Studies, 15.11.2019 22:31
Mathematics, 15.11.2019 22:31
Physics, 15.11.2019 22:31
History, 15.11.2019 22:31
