subject
Engineering, 01.11.2019 04:31 joelpimentel

Consider a laminar boundary layer formed by air flowing over a flat plate at a free-stream velocity of 2 m/s. suppose at a certain streamwise location the local streamwisevelocity is measured to be 1.7 m/s at a height of 2 mm above the plate. assumingblasius solution applies, determine: (a) the local skin-friction coefficient () the wall shear stress (τw)(c) the friction velocity (u∗)

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0
Answers: 3
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 18:20
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
You know the right answer?
Consider a laminar boundary layer formed by air flowing over a flat plate at a free-stream velocity...
Questions
question
Mathematics, 28.10.2020 21:20
question
Mathematics, 28.10.2020 21:20
question
Mathematics, 28.10.2020 21:20
question
Geography, 28.10.2020 21:20
Questions on the website: 13722362