Engineering, 07.11.2019 03:31 nik2lit

Ahelical compression spring is to be made of oil-tempered wire of 4-mm diameter with a spring index of c = 10. the spring is to operate inside a hole, so buckling is not a problem and the ends can be left plain. the free length of the spring should be 80 mm. a force of 50 n should deflect the spring 15 mm. (a) determine the spring rate. (b) determine the minimum hole diameter for the spring to operate in. (c) determine the total number of coils needed. (d) determine the solid length. (e) determine a static factor of safety based on the yielding of the spring if it is compressed to its solid length.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

Answer

You know the right answer?

Ahelical compression spring is to be made of oil-tempered wire of 4-mm diameter with a spring index...

Questions