subject
Engineering, 07.11.2019 04:31 melissarodrigue7

An airy stress function is proposed to be: phi = ax^3 + bx^2 y + cxy^2 + dy^3, where sigma_x = partial differential^2 phi /partial differential y^2 = 2cx + 6dy, sigma_y = partial differential^2 phi/partial differential x^2 = 6ax + 2by, tau_xy = -partial differential^2 phi/partial differential x partial differential y = -(2 bx + 2cy) assume a, b, c, d are constants and positive; draw a stress element showing boundary stresses for the following cases: with b=c=d=0 and x-y origin at the left edge of the element and x-y origin at the center of the element with a=d=0 and x-y origin at the center of the element. with the same case as in (2) and c=b=1, determine the boundary forces (that is, normal and shearing forces) on all the edges of a plate measuring 2 m long, 0.5 m wide and 50 mm thick.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
question
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
You know the right answer?
An airy stress function is proposed to be: phi = ax^3 + bx^2 y + cxy^2 + dy^3, where sigma_x = part...
Questions
question
Mathematics, 03.08.2019 02:30
Questions on the website: 13722361