7.10 the forward converter of fig. 7-5a has parameters vs 100 v, n1/n2 5, n1/n3 1, lm 333 h, r 2.5 , c 10 f, and d 0.25, and the switching frequency is 375 khz. (a) determine the output voltage and output voltage ripple. (b) sketch the currents ilx, i1, i2, i3, ilm, and is. determine the power returned to the source by the tertiary (third) transformer winding from the recovery storage energy in lm.

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater