Engineering, 07.11.2019 06:31 19brendaddavenport

Acomputer system designed and built in the 1970’s made use of a single 8-bit cpu-to-memory data bus and a single separate address bus. suppose that such a system contained 4 memory modules or chips, each of which was 8 bits wide with a depth of 16777216. a memory access for each module consisted of only two phases: an addressing phase in which an address is sent to select a specific memory module and cell within the module; and a data transfer phase in which the selected data item is read from or written into. each phase takes 40 nano-seconds to complete. what is the minimum time (in nano-seconds) required to read a single 32-bit data item from this memory system if it employs: a) high order interleavingb) low order interleaving

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Consider airflow over a flat plate of length l = 1.5 m under conditions for which transition occurs at le = 0.9 m based on the critical reynolds number, re,e = 5 x 10. evaluating the thermophysical properties of air at 400 k, determine the air velocity. (hint: use the tables to find the properties of air)

Answers: 3

Answer

You know the right answer?

Acomputer system designed and built in the 1970’s made use of a single 8-bit cpu-to-memory data bus...

Questions