subject
Engineering, 08.11.2019 23:31 iamthepantaloon8357

In a power generation plant, coal undergoes combustion to form co2, co, and so2. the mole fraction of sulfur in the coal is 1.1% and the rest can be assumed to be carbon. the selectivity of co2to co is 8.30. all the coal reacts (no carbon or sulfur in the exit stream). to prevent the formation of acid rain, the flue gas is passed through a scrubber to remove so2. (the removal of co, n2, o2, and co2from the scrubber can be assumed to be negligible.) 955 kg/min of water is supplied to the scrubber, the partial pressure of so2in the scrubber is 21 millibar, the exiting concentration can be assumed to be in equilibrium with the flue gas, and henry’s law constant for so2in water is 0.83 kg*bar/mol.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
question
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
question
Engineering, 06.07.2019 02:30
An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?
Answers: 3
You know the right answer?
In a power generation plant, coal undergoes combustion to form co2, co, and so2. the mole fraction o...
Questions
question
Mathematics, 05.07.2019 19:00
question
Mathematics, 05.07.2019 19:00
Questions on the website: 13722363