Engineering, 09.11.2019 01:31 ineedhelp2285
If a pitot tube were used to measure the velocity of an air stream, in the range of 1 to 10m/s, what would the corresponding range of dynamic pressure readings be? could the manometer that you employed in the pressure laboratory be used for this purpose? could the pressure transducer be used for the same purpose?
Answers: 2
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
If a pitot tube were used to measure the velocity of an air stream, in the range of 1 to 10m/s, what...
Chemistry, 22.07.2019 10:30
Mathematics, 22.07.2019 10:30
Mathematics, 22.07.2019 10:30
History, 22.07.2019 10:30
Mathematics, 22.07.2019 10:30
Biology, 22.07.2019 10:30
Mathematics, 22.07.2019 10:30