Engineering, 10.11.2019 06:31 cbrewer37

Write an arduino sketch that programs your multi-colored led so that the red and green leds are on for 500 ms, then only the blue led is on for 500 ms, then finally only the green led is on for 500 ms. this pattern of leds flashing should continue forever. circuit hint:   • you can wire up leds from digital pins 10, 11, and 12 of your arduino with a 330 ohm resistor for each led. make sure that all the grounds are connected together to arduino gnd.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Prove the equivalence between the two statements of the 2nd law of thermodynamics (i.e., a violation of one statement leads to the violatio the other statement)

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

Answers: 2

Answer

You know the right answer?

Write an arduino sketch that programs your multi-colored led so that the red and green leds are on f...

Questions