Engineering, 13.11.2019 22:31 cardenas08

Design a class named location for locating a maximal value and its location in a twodimensional array. the class contains public data field’s row, column, and maxvalue that store the maximal value and its indices in a two-dimensional array with row and column as int types and maxvalue as a double type. write the following method that returns the location of the largest element in a two – dimensional array: public static location locatelargest(double[][] a) the return value is an instance of location. write a test program that prompts the user to enter a two-dimensional array and display the location of the largest element in the array. here is the sample run: enter the number of rows and columns in the array: 3 4 enter the array:
a. 23.5 35 2 10
b. 4.5 3 45 3.5
c. 35 44 5.5 9.6 the location of the largest element 45 is at (1, 2)

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:20

Liquid flows at steady state at a rate of 2 lb/'s through a pump, which operates to raise the elevation of the liquid 100 ft from control volume inlet to exit. the liquid specific enthalpy at the inlet is 40.09 btu/lb and at the exit is 40.94 btub. the pump requires 3 btu/s of power to operate. if kinetic energy effects are negligible and gravitational acceleration is 32.174 tt/s, the heat transfer rate associated with this steady state process is most closely 1)-2,02 btu/s from the liquid to the surroundings 2)-3.98 btu/s from the surroundings to the liquid. 3)-4.96 btu/s from the surroundings to the liquid. 4)-1.04 btu/s from the liquid to the surroundings.

Answers: 2

Answer

Engineering, 06.07.2019 02:30

Around steel bar, made from material with a yield stress of 750mpa, is loaded so that it has stresses co locations of maximum normal stress and maximum shear stress. use maximum shear stress and maximum distortion energy theories to calculate the safety factors for initial yielding failures.

Answers: 3

Answer

Engineering, 06.07.2019 04:30

Asharp-edged orifice is placed in a 10-in-diameter pipe carrying ammonia. if the volume flow rate is 25 gal/min, calculate the deflection of a water manometer (a) if the orifice diameter is 1.0 in and (b) if the orifice diameter is 7.0 in. the ammonia has a specific gravity of 0.83 and a dynamic viscosity of 2.5 x 10-6 lb s/t2

Answers: 3

Answer

Engineering, 06.07.2019 05:10

Draw each component in sequence for a steam (rankine cycle) power plant. draw the system boundary needed to analyze this cycle as a closed system. note: this should just be one figure below! else

Answers: 2

Answer

You know the right answer?

Design a class named location for locating a maximal value and its location in a twodimensional arra...

Questions