Engineering, 15.11.2019 06:31 nateconn9227

A0.01 significance level is used for a hypothesis test of the claim that when parents use a particular method of gender? selection, the proportion of baby girls is less than 0.5.

assume that sample data consists of 66 girls in 144 births, so the sample statistic of startfraction 11 over 24 endfraction results in a z score that is 1 standard deviation below 0.
complete parts? (a) through? (h) below.
click here to view page 1 of the normal table. click here to view page 2 of the normal table.
identify the null hypothesis and the alternative hypothesis.
choose the correct answer below.

a. upper h 0? : pequals0.5 upper h 1? : pgreater than0.5

b. upper h 0? : pequals0.5 upper h 1? : pnot equals0.5

c. upper h 0? : pnot equals0.5 upper h 1? : pless than0.5

d. upper h 0? : pequals0.5

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Inadequate stores control is not an obstacle to effective work order system. (clo4) a)-true b)-false

Answers: 3

Answer

You know the right answer?

A0.01 significance level is used for a hypothesis test of the claim that when parents use a particul...

Questions